Table of Contents
Advertisement
SAT CONTROL SET
22
EN
Satellite Receiver Control Setting
(HDD & DVD Deck Only)
Your unit
Satellite receiver
Satellite Controller (supplied)
To [SAT CONTROL]
Back of unit
HDD
ENTER
Satellite receiver
Satellite Controller
(provided)
(suggested locations)
Transmitter
21-pin SCART cable
(supplied)
To [L-2 IN/
DECODER]
CABLE/SAT
TV
DVD
DVD
rtwe
SET UP
The following procedure is required if you receive satellite
channels through a satellite receiver. Approximately 20 seconds
a
before the
timer programming (A pg. 49) or Manual
Timer programming (A pg. 51) starts, the unit sets its input mode
to AL-2B and automatically switches the satellite receiver's channels
using the provided Satellite Controller.
Installing Satellite Controller
1
Place the Satellite Controller so that the path between its
transmitter and the satellite receiver's remote sensor is
unobstructed.
2
Fix securely using the adhesive strip attached on the back of
the Satellite Controller.
3
Be sure to connect the unit's [L-2 IN/DECODER] connector to
the satellite receiver's 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
4
Connect the Satellite Controller to the [SAT CONTROL]
connector on the rear panel.
Setting Satellite Receiver's Brand And Channel
After installation, set the satellite receiver's brand and channel
correctly; otherwise, the Satellite Controller cannot work correctly.
●
Turn on the unit.
●
Turn on the TV and select the AV mode.
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Turn on the satellite receiver's power.
2
Press HDD or DVD so that the HDD or DVD lamp lights up on
the unit.
3
Press SET UP to access the Main Menu screen.
4
Press D E to select AINITIAL SET UPB, then press G.
5
Press D E to select ATUNER
SETB, then press G.
6
Press FGD E to select ASAT
CONTROL SETB, then press
ENTER.
7
Press F G to select ABRANDB,
then press ENTER.
8
Press F G to select the brand
code from the list on page 23, then press ENTER.
●
If the unit is in playback or recording mode, you cannot set the
brand code.
9
Press F G to select APROGRAMMEB, then press ENTER.
10
Press F G to select one of the channel positions on the
satellite receiver, then press ENTER.
●
You can select the channel position between 1 to 999.
11
Press F G to select ATESTB,
then press ENTER. The unit
enters the Test mode.
DVD VIDEO SET UP
HDD/DVD SET UP
INITIAL SET UP
FUNCTION SET UP
TUNER SET
CLOCK SET
AUTO CH SET
MANUAL CH SET
SAT CONTROL SET
GUIDE PROG SET
11
12
13
SET UP
ENTER
SELECT WITH @ THEN PRESS [ENTER]
PRESS [SET UP] TO EXIT
EXIT
SELECT
INITIAL SET UP > SAT CONTROL SET
73
BRAND
12
PROGRAMME
TEST
ENTER
SELECT WITH @ THEN PRESS [ENTER]
SET UP
PRESS [SET UP] TO EXIT
EXIT
SELECT
Advertisement
Table of Contents
