Manual Timer Programming - JVC SR-DVM70EU Instructions Manual

TIMER RECORDING ON HDD/DVD DECK
46
EN

Manual Timer Programming

You can programme this unit to timer-record as many as 16
programmes.
a
If you do not know the
wish to record, use the following procedure to set your unit to
timer-record the programme.
●
Make sure that the unit's built-in clock is set properly.
●
Turn on the unit.
●
Turn on the TV and select the AV mode.
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
ENTER
1
Load a recordable disc if recording to DVD.
2
Press PROGRAMME to access the programme top screen.
3
Press FGD E to select ACALENDAR PR.B, then press ENTER.
●
When APROGRAMME FULL DELETE UNWANTED TIMER
PROGRAMMESB appears on the TV screen, you need to
cancel some of the reserved programmes. (A pg. 47)
4
Press FGD E to select the desired date, then press ENTER.
5
Press F G to select ARECORD
TOB, then press ENTER. Press
F G to select the desired
recording deck, then press
ENTER.
6
Press F G to select ASTARTB,
then press ENTER. Press F G
to set the desired start time,
then press ENTER.
● Each press of F G increases/decreases the start time in 1-
minute interval.
●
To increase/decrease the start time in 30-minutes interval,
press and hold F G.
7
Press F G to select ASTOPB, then press ENTER. Press F G to
set the desired stop time, then press ENTER.
Each press of F G increases/decreases the stop time in 1-
●
minute interval.
●
To increase/decrease the stop time in 30-minutes interval,
press and hold F G.
number for the programme you
CABLE/SAT
TV DVD
PROGRAMME
FGDE
2
PROGRAMME > CALENDAR PR. (2/3)
14/01/04 WED 22:30 - 23:00
HDD
SELECT WITH @ RECORD TO
THEN PRESS [ENTER]
22:30
START
PRESS [PROGRAMME]
23:00
STOP
TO EXIT
BBC1
TV PROG
PROGRAMME ENTER
CONFIRM
EXIT SELECT
8
Press F G to select ATV PROGB, then press ENTER. Press
F G to select the desired channel.
9
Press F G to select ACONFIRMB, then press ENTER.
10
Set the other recording options as required.
●
Refer to step 8 in Ab Timer ProgrammingB (A pg. 44).
11
Press F G to select AOKB,
then press ENTER to access
the Programme Confirmation
screen.
12
Press D E to select AEXITB,
then press ENTER to
complete timer
programming.
●
To programme another timer,
press D E to select ACONTINUEB, then press ENTER.
●
If APROGRAMME OVERLAPPEDB appears on the TV screen,
delete or modify the programmes.
NOTES:
●
When two successive programmes are recorded on a DVD-RW
disc with Manual Timer Programming function, the beginning of
the second one may be left off the recording.
●
If the copy limited programme is received during timer-recording,
the unit enters Record Pause mode. Recording starts again if it is
switched to a recordable broadcast during the time you
programmed.
Satellite Receiver Users
To timer-record a satellite broadcast using Manual Timer
Programming:
A Perform AManual Timer ProgrammingB (A pg. 46).
In step 8, set ATV PROGB to AL-2B.
B Set the satellite receiver to the appropriate channel before
the selected programme begins.
C Leave the satellite receiver's power on.
Relief Recording
When a programme that is set for the DVD deck cannot be
recorded properly, the programme is recorded to the HDD deck
instead in XP mode.
●
If the remaining capacity of the hard disc is not sufficient, the
programme is recorded to the DVD deck until the remaining
capacity of the DVD disc lasts.
●
If AJUSTB is selected for the recording mode, the current
recording mode for the DVD deck is applied.
BBC1
[MISC. ] XP
2 PROGRAMME > CALENDAR PR. (3/3)
14/01/04 WED 22:30 - 23:00 BBC1
GARDENING [EDUCATION] FR360
1:00 28:00
SELECT WITH @ INPUT TITLE GARDENING
THEN PRESS [ENTER]
CATEGORY EDUCATION
PRESS [PROGRAMME]
VPS/PDC OFF
TO EXIT
WEEKLY/DAILY
MON-FRI (FOR A WEEK)
REC MODE FR360
PROGRAMME ENTER
OK
EXIT SELECT