Manual Timer Programming - JVC DR-DX5SEK Instructions Manual

TIMER RECORDING ON HDD/DVD DECK
48
EN

Manual Timer Programming

You can programme this unit to timer record as many as 16
programmes.
If you do not know the PlusCode number for the programme you
wish to record, use the following procedure to set your unit to timer
record the programme.
●
Make sure that the unit's built-in clock is set properly.
●
Turn on the unit.
●
Turn on the TV and select the AV mode.
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
ENTER
1
Load a recordable disc if recording to DVD.
2
Press PROGRAMME to access the programme top screen.
3
Press selection keys to select ACALENDAR PR.B, then press
ENTER.
●
When APROGRAMME FULL DELETE UNWANTED TIMER
PROGRAMMESB appears on the TV screen, you need to
cancel some of the reserved programmes. (A pg. 49)
4
Press selection keys to select the desired date, then press
ENTER.
5
Press selection keys to select
ARECORD TOB, then press
ENTER. Press selection keys
to select the desired recording
deck, then press ENTER.
6
Press selection keys to select
ASTARTB, then press ENTER.
Press selection keys to set
the desired start time, then
press ENTER.
Each press of F G increases/decreases the start time in 1-
●
minute intervals.
●
To increase/decrease the start time in 30-minute intervals,
press and hold F G.
7
Press selection keys to select ASTOPB, then press ENTER.
Press selection keys to set the desired stop time, then press
ENTER.
Each press of F G increases/decreases the stop time in 1-
●
minute intervals.
●
To increase/decrease the stop time in 30-minute intervals,
press and hold F G.
CABLE/SAT
TV DVD
PROGRAMME
Selection Keys
FGDE
2
PROGRAMME > CALENDAR PR. (2/3)
14/01/04 WED 22:30 - 23:00 BBC1
[MISC. ] XP
HDD
SELECT WITH @ RECORD TO
THEN PRESS [ENTER]
22:30
START
PRESS [PROGRAMME]
23:00
STOP
TO EXIT
BBC1
TV PROG
PROGRAMME ENTER
CONFIRM
EXIT SELECT
8
Press selection keys to select ATV PROGB, then press ENTER.
Press selection keys to select the desired channel.
9
Press selection keys to select ACONFIRMB, then press
ENTER.
10
Set the other recording options as required.
●
Refer to step 8 in AVIDEO Plus+ Timer ProgrammingB
(A pg. 46).
11
Press selection keys to
select AOKB, then press
ENTER to access the
Programme Confirmation
screen.
12
Press selection keys to
select AEXITB, then press
ENTER to complete timer
programming.
●
To programme another timer, press selection keys to select
ACONTINUEB, then press ENTER.
●
If APROGRAMME OVERLAPPEDB appears on the TV screen,
delete or modify the programmes.
NOTES:
●
When two successive programmes are recorded on a DVD-RW
disc with Manual Timer Programming function, the beginning of
the second one may be left off the recording.
●
If the copy limited programme is received during timer recording,
the unit enters Record Pause mode. Recording starts again if it is
switched to a recordable broadcast during the time you
programmed.
Satellite Receiver Users
To timer record a satellite broadcast using Manual Timer
Programming:
A Perform AManual Timer ProgrammingB on this page.
In step 8, set ATV PROGB to AL-2B.
B Set the satellite receiver to the appropriate channel before
the selected programme begins.
C Leave the satellite receiver's power on.
Relief Recording
When a programme that is set for the DVD deck cannot be
recorded properly, the programme is recorded to the HDD deck
instead in the recording mode as set.
●
If the remaining capacity of the hard disk is not sufficient, the
programme is recorded to the DVD deck until the remaining
capacity of the DVD disc lasts.
●
If AJUSTB is selected for the recording mode, the current
recording mode for the DVD deck is applied.
2 PROGRAMME > CALENDAR PR. (3/3)
14/01/04 WED 22:30 - 23:00 BBC1
GARDENING [EDUCATION] FR360
1:00 28:00
SELECT WITH @ INPUT TITLE GARDENING
THEN PRESS [ENTER]
CATEGORY
EDUCATION
PRESS [PROGRAMME]
VPS/PDC OFF
TO EXIT
WEEKLY/DAILY MON-FRI (FOR A WEEK)
REC MODE FR360
PROGRAMME ENTER
OK
EXIT
SELECT