Connecting To A Dolby Digital Decoder Or An Amplifier With Built-In Dts; Connecting/Using A Decoder - JVC SR-DVM70EU Instructions Manual

SYSTEM CONNECTIONS
70
EN
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
Dolby Digital Decoder or
amplifier with built-in DTS
(not supplied)
AUDIO OUT
Note for connection:
Remove the protection cap from the optical cable.
1
Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
●
For Dolby Digital sound, set ADIGITAL AUDIO OUTB to ADOLBY
DIGITAL/PCMB. (A pg. 71)
●
For DTS sound, set ADIGITAL AUDIO OUTB to ASTREAM/PCMB.
(A pg. 71)
CAUTIONS:
●
This unit has a dynamic range of more than 110 dB with regards
to its Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to
the speakers may damage them.
●
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do
not place the speakers adjacent to the TV set as this can
adversely affect the playback picture.
To DIGITAL AUDIO
input
Coaxial cable Optical cable
(not supplied)
To [DIGITAL
To [DIGITAL AUDIO
OUT (OPTICAL)]
(COAXIAL)]
Rear of unit
When you can't switch the audio channel of a bilingual
programme
When the unit is connected with a digital audio device using an
optional optical cable and ADIGITAL AUDIO OUTB is set to
ADOLBY DIGITAL/PCMB, it is not possible to switch the audio
channel of a bilingual programme recorded on a DVD-RAM or
DVD-RW (VR mode) disc. In this case, perform the following steps
using the remote control to switch ADIGITAL AUDIO OUTB from
ADOLBY DIGITAL/PCMB to APCM ONLYB.
A Press SET UP to access the Main Menu screen.
B Press D E to select ADVD VIDEO SET UPB, then press G.
C Press D E to select AAUDIO OUTPUTB, then press G.
D Press F G to select ADIGITAL AUDIO OUTB, then press
ENTER.
E Press F G to select APCM ONLYB, then press ENTER.
(A pg. 71)
F Press SET UP to complete the setting.
G Press AUDIO to select the desired audio channel.

Connecting/Using A Decoder

The [L-2 IN/DECODER] connector can be used as an input
connector for an external decoder (descrambler). Simply connect a
decoder and you can enjoy a variety of programming that is
available through scrambled channels.
Decoder
TV
1
Set AL-2 SELECTB to ADECODERB. (A pg. 63)
2
Connect your unit's [L-2 IN/DECODER] connector to the
decoder's 21-pin SCART connector using a 21-pin SCART
cable.
3
Perform the procedure as described in AWhen Receiving A
Scrambled Broadcast (HDD & DVD Deck Only)B (A pg. 76).
TV aerial cable
[L-1 IN/OUT]
[L-2 IN/
DECODER]
RF cable (supplied)