Basic Operations On Hdd Deck; Basic Recording - JVC SR-DVM70EU Instructions Manual

Basic Recording

●
Turn on the unit.
●
Turn on the TV and select the AV mode.
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
ATTENTION:
The HDD on the unit requires approximately 20 seconds to start
up after the unit has been turned on, during which no operation
can be made.
INPUT SELECT JK
HDD
0-9
REC MODE
1
Press DV/HDD/DVD on the unit repeatedly or HDD on the
remote so that the HDD lamp lights up on the unit.
2
Press PR +/– or the number keys to select the channel you
wish to record. You can also press INPUT SELECT JK on the
unit to select.
3
Press REC MODE repeatedly to select the recording mode,
then press ENTER.
●
Each time you press REC MODE, the recording mode changes
as follows:
XP N SP N LP NEP N FR60-FR360* N FR420, FR480 N
(Back to the beginning)
* The value is selectable from 1 to 6 hours in 5 minutes interval by
D E
pressing repeatedly after selecting
value in 30 minutes interval, press and hold
●
For details on the recording mode, see the right column.
4
Press R on the unit to start recording. Or while holding R, press
I on the remote control.
●
The HDD recording lamp lights up on the unit.
5
Press o twice to stop recording.
● Pressing o once displays the confirmation message to stop
recording. Press o again to terminate recording.
NOTES:
●
Continuous recording for over 48 hours is not possible.
●
It is not possible to record on both DVD and HDD simultaneously.
DV/HDD/DVD
HDD lamp
o R
CABLE/SAT
TV DVD
PR+/-
A FR60–FR360 B . To change the
D E
.

BASIC OPERATIONS ON HDD DECK

Pause recording on HDD deck
It is not possible to pause recording. Pressing W initiates Live
Memory Playback.
However, it is still possible to pause recording only when recording
the channels of external sources (AL-1B, AL-2B, AF-1B, and ADVB).
While holding R, press W on the remote. To resume recording,
while holding R, press I on the remote.
No operation can be made with the buttons on the unit.
Recording Mode
MPEG2 format is used as recording format. As a guide for picture
quality, the AbpsB unit is used to represent how much data can be
recorded per second. The larger this value is, the better the picture
quality becomes but more capacity is required for the recording.
Select XP or SP for programmes where quick movement occurs,
such as sports programmes, and LP or EP for talk shows, etc. with
relatively less movement.
Recording mode
XP
SP
LP
EP
FR480
●
For details on FR mode, refer to AFree Rate FunctionB (A pg. 34)
NOTE:
The maximum recording time stated in the above table are the
approximate time under unused condition.
Maximum recording time (approx.)
34 hours
69 hours
138 hours
209 hours
300 hours
35
EN