Manual Timer Programming - JVC DR-M1SLE Instructions Manual

58
Manual Timer
Programming
You can programme this unit to timer-record as many as
8 programmes.
If you do not know the PlusCode number for the programme you
wish to record, use the following procedure to set your unit to
timer-record the programme.
Before performing Manual Timer Programming:
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
● Make sure that the unit's built-in clock is set properly.
TIMER RECORDING (cont.)
A
Load a disc.
A Press x to open the disc tray.
B Place a recordable disc on the disc tray.
● For details, refer to "Placing a Disc" (
C Press x to close the disc tray.
B
Access Programme Check screen.
Press PROG/CHECK.
● When "PROGRAMME FULL
DELETE UNWANTED TIMER
PROGRAMME" appears on
the TV screen, you need to
cancel some of the reserved
programmes. ( pg. 63)
C
Access the programme screen.
Press rt repeatedly to
select "NEW TIMER
PROGRAMME", then press
ENTER.
D
Enter the recording date.
Press rt repeatedly to set the desired date.
● The current date appears on the TV screen. The date you enter
appears in its place.
E
Enter the recording start time.
Press w e to select "START", then press rt repeatedly
to set the desired start time.
● Each press of rt advances/goes back the start time in 1-min.
increments.
● To advance/go back the start time in 30-min. increments, press
and hold rt.
pg. 10).