Figure 21. RTRM Zone Sensor/Thermostat Connections
Remote Panels and Sensors
Constant Volume Control Options
The RTRM must have a zone sensor or conventional thermostat to operate the rooftop unit. If using
a zone sensor, mode capability depends upon the type of sensor and/or remote panel selected to
interface with the RTRM. The possibilities are: Fan selection ON or AUTO, System selection HEAT,
COOL, AUTO, and OFF . Refer to
The following Constant Volume controls are available from the factory for field installation.
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow proper
lockout/tagout procedures to ensure the power can not be inadvertently energized. Failure to
disconnect power before servicing could result in death or serious injury.
Zone Panel (BAYSENS106*)
This electronic sensor features three system switch settings (Heat, Cool, and Off) and two fan
settings (On and Auto). It is a manual changeover control with single setpoint capability.
RT-SVX34C-EN
INPUTS
ZSM INPUTS
CV/VAV
ZSM INPUTS
WARNING
(CV ONLY)
Figure 21 on page 41
for conventional thermostat connections.
Installation Electrical
41