Advertisement
Problem
Dust or dirt
The CMOS sensor
particles appear in
is dirty or dusty.
images.
There are visible
defects in a
captured image, or
There are
parts in the display
defective pixels in
monitor that do not
the CMOS sensor.
6
light up or remain
lit.
84
Cause
Remedy
Activate [Dust Removal] from
the D4 menu. The Dust
Removal function can be
activated every time the camera
is turned on and off.
Use a brush-less blower to
remove dirt and dust from the
CMOS sensor. Using a blower
with a brush may scratch the
CMOS sensor. Do not wipe the
CMOS sensor with a cloth.
Attach a lens cap to a lens that
has a lens shutter, such as the
01 STANDARD PRIME, and
perform [Pixel Mapping] of the
D4 menu.
It takes about 30 seconds to
correct the defective pixels, so
be sure to install a fully charged
battery.
Error Messages
Error Messages
The memory card is full and no more
Memory card full
images can be saved. Insert a new
memory card or delete unwanted files.
There are no images that can be played
No image
back on the memory card.
You are trying to play back an image in a
This image cannot be
format not supported by this camera. You
displayed
may be able to play it back on a computer.
There is no memory card inserted in the
No card in the camera
camera.
The memory card has a problem,
and image capture and playback are
impossible. You may be able to play
Memory card error
it back on a computer.
Failed to initialize Eye-Fi function when
using the Eye-Fi card. Press E.
The memory card you have inserted is
unformatted or has been used on another
Card is not formatted
device and is not compatible with this
camera. Use the card after formatting it
with this camera.
The write-protect switch on the memory
Card is locked
card you have inserted is locked. (p.100)
This image cannot be
You are trying to magnify an image that
magnified
cannot be magnified.
You are trying to delete an image that is
This image is protected
protected. Remove protection from
the image. (p.73)
Description
Advertisement
