Advertisement
uCaution
• Do not use the battery charger D-BC68P to charge batteries
other than D-LI68. Charging other batteries may cause
damage or heating.
• Replace the battery with a new one in the following cases:
• If the indicator lamp blinks or does not light after the battery
is inserted correctly
• If the battery starts to run down more quickly even after
being charged (the battery may have reached the end
of its service life)
tMemo
• The maximum charging time is approximately 115 minutes
(it depends on temperature and remaining battery power).
Charge in a location where the temperature is between
0°C and 40°C (32°F and 104°F).
Inserting/Removing the Battery
uCaution
• Insert the battery correctly. If the battery is inserted
incorrectly, it may not be removed.
• Wipe the electrodes of the battery with a soft dry cloth before
inserting.
• Do not open the battery cover or remove the battery while
the power is on.
• Be careful as the camera or battery may become hot after the
camera has been used continuously for a long period of time.
• Remove the battery when you will not use the camera for
a long time. The battery may leak and damage the camera
if left installed during prolonged periods of non-use. If the
removed battery will not be used for six months or longer,
charge the battery for about 30 minutes before storing it.
Be sure to recharge the battery every six to twelve months.
• Store the battery in a location where the temperature will
remain at or below room temperature. Avoid locations with
high temperatures.
• The date and time may be reset if you leave the battery
out of the camera for long periods of time. If this happens,
set the current date and time again.
1
Slide the battery cover
in the direction of 1.
2
Insert the battery until it locks
into place with the A mark
facing toward the lens.
To remove the battery, push the
battery lock lever in the direction
of 3.
3
Close the battery cover, and
slide it in the direction of 5.
2
1
2
3
5
4
25
Advertisement
