Removing The Microwave Door Interlock Switches And The Cavity Light - KitchenAid KEMS378S Technical Education

REMOVING THE MICROWAVE DOOR INTERLOCK
SWITCHES AND THE CAVITY LIGHT
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug oven or disconnect power.
2. Open the microwave oven door, remove
the two flat-head screws from the bottom
of the control panel frame, and remove the
frame.
Control Panel Frame Screws
3. Remove the four screws from the front
subpanel and remove the subpanel as-
sembly.
Front Subpanel Screws
4. Disconnect the P1 and P2 connectors from
the microwave and lower oven control board
connectors and set the panel assembly
aside.
Lower Oven Board
P2 P1
MW Oven Board
P2 P1
Sec. Interlock Sw.
5. To remove the secondary interlock
switch:
a) Remove the two mounting bracket
screws from the front of the switch
holder on the left front side of the MW
oven, and remove the holder.
Sec. Interlock Sw. Screws
b) Disconnect the blue (COM) and white
(N.O.) wires from the switch termi-
nals.
c) Raise the locking tabs and pull the
switch off the pins and out of the switch
holder.
Secondary Interlock Sw.
Continued on the next page.
4-7
Cavity Light
Primary & Monitor
Interlock Switches
BU (COM)
WH (N.O.)