KitchenAid KEMS378S Technical Education page 30

6. To remove the primary or monitor in-
terlock switch:
a) Place the blade of a flat-blade screw-
driver between the switch body and the
holder. Twist the blade until the switch is
free of the tabs, and remove the switch
from the holder.
Monitor Interlock Switch
Twist Screwdriver
b) Primary (front): Disconnect the brown
(COM), white (N.O.), and blue (N.C.)
wires from the switch terminals.
BR (COM)
WH (N.O.)
BU (N.C.)
Primary Interlock Switch
Primary Interlock Switch
c) Monitor (rear): Disconnect the red
(COM) and blue (N.C.) wires from the
switch terminals.
RD (COM)
BU (N.C.)
Monitor Interlock Switch
7. To remove the cavity light:
a) Disconnect the two pink cavity light
LOAD wires from the microwave light
transformer terminals.
Pink LOAD Wires
Microwave Light
Transformer
b) Squeeze the light wire clips, remove
the ends from the slot in the chassis,
and lift the light and remove it from the
chassis.
Cavity Light
4-8
Wire Clip
Chassis Slot