Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
DOOR LATCH ASSEMBLY
Refer to page 4-28 for the procedure for ac-
cessing the door latch assembly.
NOTE: The door latch assembly components
will be tested at the appliance manager board
(see page 4-18).
1.
Unplug oven or disconnect power.
2.
Set the ohmmeter to the R x 1K scale.
3.
Touch the ohmmeter test leads to the wire
connectors. The meter should indicate as
shown below:
Latch Switch: P1-4 (TN) and P1-5 (BR).
The meter should indicate an open circuit
(infinite) with door unlocked, and a closed
circuit (0 Ω) with the door locked.
Door Switch: P1-7 (OR) and P1-5 (BR).
The meter should indicate an open circuit
(infinite) with door unlocked, and a closed
circuit (0 Ω) with the door locked.
Latch Motor: P8-5 (YL) and the neutral (WH)
stud on the AC terminal block. The meter
should indicate approximately 2450 Ω.
LOWER OVEN COMPONENTS
Electrical Shock Hazard
WARNING
Lower Oven
Appliance Manager
5-10
1 2 3 4 5 6 7
P1
P8
6 5 4 3 2 1