Will Burt Night Scan Chief Installation, Operation & Maintenance Manual page 63

SECTION F: EMERGENCY AND FIRST AID PROCEDURES
Skin contact: Remove contaminated clothing and wash with soap and water. If irritation occurs
get medical attention.
Eye contact: Flush with water for 15 minutes. If irritation occurs get medical attention.
Ingestion: Do not induce vomiting. Get medical attention.
SECTION G: SPECIAL PROTECTION / SPILL AND LEAK PROCEDURES
Ventilation:
Mechanical (general):
Protective gloves:
Eye Protection:
Respiratory Protection: As needed to prevent overexposure to mist or fumes. Use NIOSH
Other protective clothing or equipment: Use chemically resistant apron as needed.
SECTION H: ENVIRONMENTAL PROTECTION / SPILL AND LEAK PROCEDURES
Spill or Leak: Recover free product. Add sand, earth or other suitable absorbent to spill area.
Minimize worker contact. Keep from sewers or waterways by diking or
impounding. Advise authorities if product enters waterways or extensive land
areas. Dispose of recovered material and residue in compliance with all federal,
state, and local regulations.
Waste Disposal: Dispose of all waste products in accordance with all applicable federal, state and
local regulations.
Handling and Storage Precautions:
Consider this product to be non-hazardous. No special labeling required by DOT.
The ingredients of this product are on the TSCA Inventory.
The information contained herein is based on the data available to us and is believed to be
correct. The Will-Burt Company does not warrant or guarantee their accuracy or reliability and
The Will-Burt Company shall not be liable for any loss or damage arising out of the use thereof.
The information and recommendations are offered for the user's consideration and examination
and it is the user's responsibility to satisfy itself that they are suitable and complete for its
particular use.
FORM No. ENG- 330 - 95 – 03
Local exhaust – required only to capture vapor, mist or fumes.
As required to prevent exceeding recommended exposure limits.
Use chemically resistant gloves to avoid prolonged skin contact.
Use safety glasses or goggles to prevent eye contact.
approved chemical mist and organic vapor respirators.
Keep container closed when not in use. Do not store
near heat, open flame or strong oxidants.
SECTION I: TRANSPORTATION REQUIREMENTS
DOT Shipping Regulations:
SECTION J: OTHER REGULATORY CONTROLS
7/7/00
A 3