Installation; Introduction; Tools And Materials Required For Installation; Table 2-1. Tools And Materials Required For Installation - Will Burt Night Scan Chief Installation, Operation & Maintenance Manual

Safety Instruction -Trained Personnel Only! Only trained and qualified personnel should perform
installation, adjustments, and servicing. Only a properly trained and qualified certified electrician should
Safety Instruction -Trained Personnel Only! Only trained and qualified personnel should perform
installation, adjustments, and servicing. Only a properly trained and qualified certified electrician should
Lifting Hazard! Manually lifting over 55 lb (25kg) is prohibited. In the UK, all lifting equipment must be
thoroughly examined annually by a competent person according to the Lifting Operations and Lift Equipment
Regulations 1998. Equivalent regulations exist in other EU states.

2.1 INTRODUCTION

The Chief has been designed to provide for ease of installation. This section of the manual provides the
procedures that must be followed to insure a successful installation. Be sure to read and understand the
entire installation procedure before you begin.

2.2 TOOLS AND MATERIALS REQUIRED FOR INSTALLATION

Table 2-1 provides a list of tools and materials required to install and test the Night Scan Chief.
Wrenches
Screwdrivers
½ inch or M12 Mounting Hardware (6 each)
Torque wrench
Drill
Hoist (minimum 250 lb capacity)
Revision 1
CHAPTER 2

INSTALLATION

perform electric installations and service.
perform electric installations and service.

Table 2-1. Tools and Materials Required for Installation

Crimping tool or Solder set
Wire cutter/stripper
Multimeter (to verify power is turned OFF)
Clean Shop Rags
Night Scan Chief
2-1