Figure 4-4 Dip Switch Location: Chief Base Board; Figure 4-5 Dip Switch Location: Chief Rcp Board - Will Burt Night Scan Chief Installation, Operation & Maintenance Manual

To set the operational mode for the RCP board, locate the DIP switch S1 (see Figure 4-5) and set the DIP
switch as follows:
•
Position 1 - Close to cause the RCP to self stow if there is an error.
•
Position 2 – DO NOT CLOSE.
•
Position 3 – DO NOT CLOSE
•
Position 4 – DO NOT CLOSE
Revision 1
Figure 4-4 DIP switch location: Chief base board
J4
Figure 4-5 DIP switch location: Chief RCP board
S2
Night Scan Chief
4-6