To Cancel An Alarm; To Reset After An Alarm - Texecom Veritas Excel Master User Manual

Veritas Excel Master User Guide

To CANCEL an Alarm

The display will look like this:
Enter your 4-digit Access code
sounders will stop but the external strobe will continue to flash.
! "
If you were not present when the alarm activated, the internal and external
sounders will have already stopped after a pre-programmed time. The system will
re-arm but the external strobe will continue to flash.

To RESET After an Alarm

The display will look something like this:
! "
The number of the zone that caused the alarm will be flashing (in this case Zone 6)
and the numbers of all subsequent zones violated (if any) will be on (in this case
Zones 7 & 8).
It is advisable to make a note of the zone that caused the alarm as this information
may be required by your alarm company.
To display the descriptive text associated with a particular zone number, press
and hold the corresponding key
Press to acknowledge the alarm, the external strobe will stop, the system will
,
chime and the display will return to normal.
! "
If the system has been programmed to be reset by an engineer, pressing
will not return the display to normal. If this is the case contact your alarm
company.
The system may have been programmed to be reset by Anti-Code, if this is the
case, see page 8 for details.
INS166-2
D3$/0$%1#*$.
G"A.%D/00+"<$
####
@A33%B$*
=3/.?0:::::5EL::
@A33%B$*
=3/.?0::::::EL::
Operating the Alarm System
Zones
1 2 3 4 5 6 7 8
Zones
1 2 3 4 5 6 7 8
Zones
1 2 3 4 5 6 7 8
(LCD keypad only).
#
Unset
Tamper
, the internal and external
Unset
Tamper
Unset
Tamper
,
7