Personal Attack; Master User - Texecom Veritas Excel Master User Manual

Programming the Alarm System
There are eight possible User Access Levels:
User
%
A User may set, unset, silence an alarm and reset the system. In addition a User can test
the system outputs, perform a walk test and view the Event Log. A User cannot change
Access codes (other than their own) or Access Levels.
Engineer
&
Engineers cannot change Access Levels or Access codes (other than their own).
However they can access all system programming options.

Personal Attack

Entering a PA code will cause an immediate alarm, sounding both the internal and
external sounders.
Duress
'
A Duress code behaves exactly as a User code (Level 1) but will in addition activate the
Duress channel on the communicator interface to secretly summon assistance.

Master User

1
A Master User may set, unset, silence an alarm and reset the system. In addition a
Master can test the system outputs, perform a walk test and view the Event Log. A
Master User can also assign new user Access code and Access Levels.
Cleaner
.
If the system is full set or part set then a Cleaner code will automatically omit the Cleaner
Suite zones without affecting the other zones. In addition pressing a key will NOT cause
the system to start entry mode. On leaving, the cleaner should enter their Access code
####
previous set will be restored irrespective of which key was pressed. A cleaner cannot
access Chime. Nor can they cancel an alarm or reset the system.
! "
When a cleaner is Setting the system the Cleaner Suite zones will flash indicating that
they are currently omitted but are about to be re-included. Any other omitted zones
(e.g. if the system was previously part set rather than full set) will also flash but will NOT
be included. If the system is unset then a cleaner can full set, part set and omit zones.
16
!
and press either
Veritas Excel Master User Guide
or . The
$ (
key is disabled and the
)
INS166-2