Page 1
ComGSM Module Installation Manual THANK YOU FOR VOTING TEXECOM INSTALLATION MANUAL GSM Communicator Module Issue 1...
Page 2
ComGSM Module Installation Manual Introduction The ComGSM module can be connected to the Premier 24/48/88/168/640 control panels to provide the following facilities: • Report system events (alarms, arm, disarm etc.) via text messaging to mobile telephones • Remotely arm, disarm and obtain current status of the alarm system via text messaging •...
No GSM Signal Bright = Good Signal Installation The ComGSM module should be installed as close to the control panel as possible, so that the harness lead supplied with the unit is able to plug onto the control panel communication port.
Panel Configuration Before attempting to use the ComGSM module it must be correctly configured as follows: Enter “Engineers Programming” mode and select “UDL/Digi Options”, then select “Com Port Setup”. Ensure Com Port is programmed as “GSM Module”.
Page 5
ComGSM Module Installation Manual Using the SMS Control Commands Control commands can be sent to the ComGSM module to allow remote control and integration of the alarm system. Select the send text message option on your mobile telephone. Enter the telephone number of the ComGSM module.
Page 6
ComGSM Module Installation Manual Premier 48/88/168/640 SMS Control Commands Operation Command Example “5678 arm s” = arm all areas and report back Arm System ???? arm [areas][s] status. Part Arm System ???? parm (1/2/3)[s] “5678 parm 1” = part arm 1 all areas (no status) “5678 darm abcs”...
As a result the Premier ComGSM module is covered by a two-year warranty against defects in material or workmanship. As the Premier ComGSM module is not a complete alarm system but only a part thereof, Texecom cannot accept responsibility or liability for any damages whatsoever based on a claim that the Premier ComGSM module failed to function correctly.
Need help?
Do you have a question about the ComGSM and is the answer not in the manual?
Questions and answers