Connecting To A Computer; Connecting To External Devices With Component Input - Baumann Meyer DT2620D Operating Instruction

Connections and Start of Operation

Connecting to a Computer

You can use the television set as a monitor for the computer. This is possible parallel to television operation.
Use a 15-pin D-Sub cable to connect the television set to the computer.
If the television set does not receive any signal, adjust the output of the
computer. For information on how to setup the computer, refer to the
corresponding manual of the computer.

Connecting to External Devices with Component Input

You can use the television set to connect DVD recorder/player and set-top-box. Connect the audio and video cables
from the external equipment's output jacks to the TV input jacks, as shown in the figure. When connecting the TV to
external equipment, match the jack colors.
➤ Connecting to External Devices
If the external equipment has mono audio output, connect it only to left socket
of the audio input/output.
14
1 Plug the cable into the output socket of the
graphic board.
2 Plug the other end of the cable into the socket
[RGB].
3 Connect the audio cable according to the
colours to the socket [AUDIO] on the television
set and the output sockets of the graphic board.
Adjust the settings of the television picture
corresponding to the settings for television
operation. See "Settings" on Page 17.
1 Plug the video cable according into the colours to
the output sockets of the external devices.
2 Plug the other end of the video cable according to
the colours into the Y, Pb, Pr sockets
[COMPONENT1 or COMPONENT2] on the
television set.
3 Plug the audio cable according to the colours to
the audio output sockets of the external devices.
4 Plug the other of the audio cable according to the
colours into the audio input socket on the
television set.