Connecting To The Roof Aerial - Baumann Meyer DT2620D Operating Instruction

➤ Connecting to a Device without SCART Socket
Use a coaxial cable to connect the units.

Connecting to the Roof Aerial

Ensure that the roof aerial is properly installed and grounded.
If the roof aerial is not properly grounded, voltage may damage the unit and
static charges may build up.
1
Rear of the TV
2
Rear of the TV
Connections and Start of Operation
1 Plug the coaxial cable into the socket [ANT] on
the television set.
2 Plug the other end of the coaxial cable into the
output socket on the receiver.
1 Plug the coaxial cable of the roof aerial into
the socket [ANT].
☛
If both analog and digital signals are available,
1
connect each signal to the corresponding
antenna jack.
If only one antenna signals is available
2
connect the signal to DTV Antenna input jack
and then connect the signal of the DTV Loop
Out jack to the analog antenna jack with
supplied antenna loop cable. (Option)
11