Assembling The Interwrite Marker Pen - Interwrite Learning Interwrite Board Getting Started

Interwrite Board
40
TM

Assembling the Interwrite Marker Pen

The electronic Interwrite Marker Pen can be used in both Interactive
Mode and Whiteboard Mode. It is used uncapped in Whiteboard Mode to
apply dry-erase ink on the Interwrite Board. Whatever you write or draw
with the uncapped Marker Pen is mirrored on the computer screen. The
capped Marker Pen is used in Interactive Mode to apply virtual ink, in the
same way the Interactive Pen does. The small felt eraser on the end of the
Marker Pen will erase both the real dry-erase ink and virtual ink. Replace-
ment erasers and Pen Caps are included in the Accessory Kit.
Marker
Holder
Left – Double-Click Mouse
1 Locate the pen components shown here. Separate the Marker Holder
from the Electronics Module by depressing the Clip on the underside of
the Electronics Module and pulling the two apart.
2 Remove the Battery Cover on the Electronics Module by pushing forward
on the thumb grip. Insert the supplied AAA battery into the battery
compartment, positioning it properly to ensure the correct polarity.
Replace the Battery Cover.
3 Remove the Marker's colored cap and discard it. Replace it with one of
the supplied Pen Caps.
4 Insert the Marker with the Pen Cap in place into the Marker Holder.
Marker
Pen Cap
Assembled Interwrite Marker Pen
Button with Pen Up
Windows and Mac
Getting Started
Electronics Module
LED
Right – Right Mouse Button
(Windows)
Ctrl-Click (Mac)
Pen Tip – Up or Down
Same as Left Mouse Button
on Windows and the Mac
Eraser
Battery
Clip
Cover