Install The Btcom2 Module On The Interwrite Board - Interwrite Learning Interwrite Board Getting Started

Getting Started

Install the BTCOM2 Module on the Interwrite Board

The BTCOM2 Module allows Interwrite Boards to operate wirelessly,
eliminating the need for a serial or USB cable connection between your
Interwrite Board and your computer. If either cable connection is in place,
disconnect it before installing your BTCOM2 Module.
The BTCOM2 Module is installed on the Interwrite Board. It communicates
with the external or built-in Bluetooth module on the computer.
2 Power Connector
nd
RJ12 BTCOM2 Port
Pen Prox LED
Power LED
Power Switch
Power Connector
Controller
Serial Connector
USB Connector
3 You will attach the BTCOM2 Module
to the back of the Interwrite Board.
Remove the paper covering the
adhesive strip on the BTCOM2 Base.
Position the Base on the back of the
Interwrite Board at the top corner, on
the controller housing side. Press
firmly to affix the adhesive strip to
the back of the Interwrite Board.
4 The BTCOM2 Module should be
positioned with the Bluetooth logo
facing forward. Route the RJ12 cable
through the cable guide on the Base.
5 Plug the RJ12 Connector into the RJ12
Port (it looks like a phone jack) on
the top side of the controller housing.
6 Attach the Power Supply, if you have
not already done so. Power on your
Interwrite Board. The Power LED will
light up and you will hear four beeps
that indicate the power is on,
followed by one beep when the
Interwrite Board has recognized the
BTCOM2 Module.
Interwrite
1 Toggle the Power Switch to
power off the Interwrite Board.
2 Remove the serial or USB
connector from the Interwrite
Board, if it is still connected.
BTCOM2
Module
Base
Paper Strip
The RJ12 Port and Power
Connectors are on the top
of the Controller. Do NOT
attempt to plug a USB
Connector into the RJ12 Port.
RJ12 Port
RJ12 BTCOM2
Connector
BTCOM2
Base
Interwrite Board
Frame
Board
19
TM