Connect Your Interwrite Board Cable Installation - Interwrite Learning Interwrite Board Getting Started

Interwrite Board
16
TM
Connect Your Interwrite Board:
Cable Installation
The Interwrite Board is connected to the computer either via a cable, or
wirelessly. If you are not using the Bluetooth wireless communication system
described next, you can connect your Interwrite Board to the computer using
either the supplied USB cable, or the serial cable. Do not use both cables.
Choose one or the other to connect the PC and the Interwrite Board. The
Mac can be connected to the Interwrite Board only with the USB cable.
The connectors and switches on the Interwrite Board Controller are shown
in the graphic below. Please note that the Controller on your Interwrite
Board has two power connectors, one on the top of the Controller and one
on the side. Plug the Power Supply into the Power Connector on the side of
the Controller. The Power Supply is not necessary if you are using a USB
connection. However, if you are using a serial connection, attaching a
BTCOM2 Module for wireless communication, or attaching the optional Pen
Charging Station, you must connect the Power Supply. The Pen Charging
Station, if you have one, is plugged into the Power Connector on the top of
the Controller.
Use either a Serial or a USB connection, never both.
There is only one Connector for USB. It is on the side of the Controller, as
shown in the photo. The Connector located on the top of the Controller
with the Power Connector is the RJ12 Connector for the BTCOM2
Module.
2 Power Connector
nd
RJ12 BTCOM2 Port
Pen Prox LED
Power LED
Power Switch
Power Connector
Controller
Serial Connector
USB Connector
Getting Started