Calibrating The Interwrite Board - Interwrite Learning Interwrite Board Getting Started

Getting Started

Calibrating the Interwrite Board

1 Aim the projector at the Interwrite Board's writing area, and size the
projected desktop image to fit within the writing area. Make sure the
image is properly projected on the Interwrite Board before continuing.
2 Using your electronic Interwrite Pen, click on the Calibrate icon
located on either of the Interwrite Board Menus.
Calibration Point
Calibration Screen
If an error occurs during calibration, simply abort the operation and
start over.
Recalibrate the Interwrite Board whenever the projector or the
Interwrite Board has been moved.
The video projector should be utilized to project an image of the computer
desktop on the Interwrite Board only when Interwrite Workspace is operating
in Interactive Mode . The video projector should not be used when Interwrite
Workspace is operating in Whiteboard Mode .
When calibration is complete, you are ready to begin using Interwrite
Workspace to annotate captured screens and presentation pages on your
Interwrite Board. The next section of this Getting Started guide gives you an
overview of the Interwrite Workspace software.
Interwrite
A blue calibration screen with a white
Calibration Point in the upper left corner
will display on the projected image on the
Interwrite Board.
3 Using an electronic Interwrite Pen,
click on each of the Calibration Points
as they appear on the Interwrite
Board. A bell tone will accompany
each successful click. Click the left
mouse button on the Pen (Windows
only) to repeat a point. Click the right
mouse button (Windows only), or type
the Esc key on the computer (both
Windows and Mac), to abort the
calibration.
Board
29
TM