Mounting The Interwrite Board On The Floor Stand - Interwrite Learning Interwrite Board Getting Started

Getting Started
Mounting the Interwrite Board
on the Floor Stand
The Interwrite Board is attached to the floor stand with the provided Knob
screws—two on each side of the board.
Two people should mount the Interwrite Board on the floor
stand to avoid injury, or damage to the Interwrite Board.
Floor Stand
3 With one person at each end of the Interwrite Board, position the
Mounting Brackets on either side of the Floor Stand Legs. Thread the top
Knob screw through the Slide Slot in the Mounting Bracket and into the
hole closest to the front edge of the Floor Stand. Screw the second Knob
screw through one of the Ratchet Slots in the Mounting Bracket and into
the screw hole positioned in the middle of the second, lower set of four
Crossbar screws.
The position of the Interwrite Board on the floor stand can be adjusted by
standing in front of the Interwrite Board, grasping the bottom of the board
with both hands, and sliding it up or down, coming to rest on one of the
Ratchet Slots in the Mounting Brackets.
One person can adjust the position of the Interwrite Board up or down,
but be sure to stabilize the floor stand before you attempt to reposition
the board. Lock down the thumb tabs on the Casters, or push the floor
stand against a wall to prevent it from rolling, or put one of your feet on
the Floor Stand Foot to hold it in place as you adjust the Interwrite
Board's position.
Position the floor stand on a level surface to avoid tipping.
Lower the Interwrite Board to the lowest position on the floor stand
before moving the stand.
Do not hang objects on the Interwrite Board.
Knob
screws
Interwrite Board
TM
Slide Slot
Knob screws
Ratchet Slot
13