Horizontal Stabilizer Preparation - Pipistrel Sinus Build Manual

Horizontal stabilizer preparation

After manufacture, the seam, which separates the upper and lower halves of the horizontal
stabilizer, is a little rough and needs to be cleaned up.
Sand the leading edge with 1500 wet and dry to get a perfect finish. If there are any

little holes in the seam, fill them with white flexible polyester filler.
http://www.pipistrel.si
K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
© Pipistrel Release March 2009 © Page 81 of 267