Fitting The Engine (Part 1) - Pipistrel Sinus Build Manual

Fitting the engine (part 1)

Fresh out of the box, your Rotax engine should look like this:
First remove the carburetors. They are mounted to the intake manifold with rubber

sleeves and hose clamps. Loosen the clamps and remove the carburetors.
Next you need to disconnect the electronics and remove the intake manifolds .

Mark the black box's connectors (i.e. which wire goes with which wire). If wrongly

reconnected later, you may damage the engine. Be careful not to drop any washers into
the magneto.
Also mark the crankcase just below the intake manifold with cylinder numbers 1 to 4.

http://www.pipistrel.si
K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
© Pipistrel Release March 2009 © Page 126 of 267