Fitting the lower fuel system
Preparing the firewall:
Cut 2 holes, 22 mm in diameter, side by side into the firewall as shown in the photo
below. Use a Dremel to grind the center section so you end up with a slot.
There are three components that you need to complete this step. The first part has a T
piece with 2 silicone tubes and a rubber hose. The second piece is rubber and silicone
tube, which is used for the fuel return line. The third is a smaller junction, which connects
the gasculator and fuel filler/drain.
http://www.pipistrel.si
K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
© Pipistrel Release March 2009 ©
ds
Page 49 of 267