Lining The Fuselage Interior With Carpet And Mounting The Fuel Taps - Pipistrel Sinus Build Manual

Lining the fuselage interior with carpet and mounting the fuel taps

Fit carpet to the roof and sides of the cabin using contact adhesive, which is applied to

both the fuselage sides and the carpet. Use the "paint on" type of contact adhesive for
the fuselage and "spray" type of contact adhesive on the carpet. If this is not done, the
carpet soaks up a lot of weight with excess glue. Allow both to dry until they are not
sticky and then mount the carpet
Fit the carpet on the roof first, starting at the rear and working forwards. Make sure the

carpet is centered and does not run up the sides of the fuselage otherwise it will interfere
with the carpet on the sides of the wing root and also interfere when fitting the wings to
the aircraft.
http://www.pipistrel.si
K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
© Pipistrel Release March 2009 © Page 29 of 267