Fitting The Brake Lines - Pipistrel Sinus Build Manual

Fitting the brake lines

Feeding lines from under the fuselage, through the cabin floor and into the cabin:
Feed the brake lines from under the fuselage into the cabin through the holes located

directly in front of the undercarriage legs. It is important to leave a loop in the ends
under the landing leg. If you pull it too tight you may damage the brake lines on the
edge of the drilled hole.
Drill a 10 mm diameter hole just in front of the rudder cables in the center tunnel for the

exit of one brake line. It should be offset 10 mm to the right of center (when looking
towards the front of the aircraft).
http://www.pipistrel.si
K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
© Pipistrel Release March 2009 © Page 111 of 267