Fitting The Ballistic Chute (Part 1) - Pipistrel Sinus Build Manual

Fitting the ballistic chute (part 1)

If you have ordered a chute with your kit, the factory will have marked the position and shape of
the hole with marker pen on the top of your aircraft.
Mask over the area with packaging tape to stop the surface getting damaged when you

cut the chute opening with a jig saw.
Drill 4 small holes and a slot to start the cut with a jigsaw. Be sure to measure the

jigsaw blade width first and use a drill with the same drill piece thickness as the jigsaw
http://www.pipistrel.si
K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
© Pipistrel Release March 2009 © Page 37 of 267