Drilling The Rudder Cable Holes; Running The Rudder Cable Outers - Pipistrel Sinus Build Manual

Drilling the rudder cable holes

Drill the holes for the rudder cables in the rear bulkhead. Each hole has a diameter of

6mm hole. Also drill the bulkhead underneath the seats in the marked locations.

Running the rudder cable outers

The rudder cable outers run from the cockpit (just in front of the pedal adjustment knob) to just
beyond the first rear bulkhead.
Mount the rudder cable outers using the supplied pressure hose

Feed them under the seats towards the rear bulkhead as shown below

http://www.pipistrel.si
K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
© Pipistrel Release March 2009 © Page 58 of 267