Fitting The Cockpit Carpet - Pipistrel Sinus Build Manual

If you notice that the fuselage fiberglass is built up a little too thick in the area where you

are mounting the fuel tap, be sure to grind down the fiberglass a little and/or enlarge the
hole.

Fitting the cockpit carpet

Four pieces of carpet are to placed on the cockpit's front wall (behind the motor).
The two identical side pieces should be placed first, then the thin upper piece and then

the main piece.
Before placing the thin upper piece, cut a small triangle out of the upper edge to make

room for the windscreen's placement clip.
Using the adhesive spray, coat the insulation material and spray the carpet which goes on

the inside of the firewall, allow to dry then position and mount the carpet.
When dry using the soldering iron with a knife blade cut the openings in the carpet for the

additional holes.
http://www.pipistrel.si
K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
© Pipistrel Release March 2009 © Page 32 of 267