Fitting the front cowls
Connecting the two cowls and fitting the seam screws:
The cowls have small indents along the rim where they connect together. These indents
indicate where the first set of holes are to be drilled. Mark them with a pen and put the
two halves together. Hold them together with tape.
The two halves should fit together nicely. If this is not the case, use a file to straighten
out any rough edges.
Drill a 3mm hole through both cowls and secure with a small screw. Repeat this for the
remaining holes. Turn and complete the other side.
Separate the two sides and redrill the top cover's 3mm holes with a 6.2mm drill bit for
the quick connect screws.
http://www.pipistrel.si
K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
© Pipistrel Release March 2009 ©
Page 178 of 267