Connecting The Power Cord - Winnebago Itasca Ellipse Owner's Manual

SECTION 6 –
ELECTRICAL
be used is designed to mate with the prongs of the
power cord plug, the electrical connection can be
expected to carry rated load.

Connecting The Power Cord

To connect to an external source, remove the
cord from the utility compartment and plug it into
a suitable 50-amp power receptacle to provide
external power to the coach and converter/
charger system.
NOTE: Some parks do not have 50-amp service
available, so you will need to connect to
a standard 30-amp service pole using an
adapter.
50 Amp.
Power Receptacle
A flip-down hatch lets you route the power
cord out the bottom of the compartment so you
can close the compartment door while the power
cord is connected.
1. Flip the hatch downward.
6-2
30 Amp Receptacle
2. Swivel the cover section aside to reveal cord
notch.
3. Route the cord through the notch and flip the
hatch back up into place and close the
compartment door.
NOTE: Always keep service access passage
closed while utility connection is not in
use.
Park Fuses or Breakers
Most campgrounds are equipped with a fuse
or circuit breaker at the receptacle. This protects
the park's wiring, as well as the power cord on
your vehicle, from electrical damage. If electrical
power fails, contact the park attendants and have
them check the fuse or breaker for your supply
receptacle.
After disconnecting the power cord, neatly
stow it in the utility compartment.