Washer/Dryer - Winnebago Itasca Ellipse Owner's Manual

SECTION 4 –
APPLIANCES AND SYSTEMS

WASHER/DRYER

–If Equipped
To Open the Door During a Wash Cycle
Follow these steps if you need to open the
door to your washer/dryer after a cycle has
already begun.
1. Advance the Program Selector to "Reset" and
wait 5 seconds.
2. Advance the Program Selector to "Drain" (8
o'clock) and allow the machine to drain
completely.
3. Advance the Program selector to "Reset" (the
"Status/Door Lock" LED will blink quickly to
indicate that the cycle has stopped, but the
door is STILL LOCKED).
4. When the "Status/Door Lock" LED blinks
SLOWLY (takes 1-2 minutes), you can open
the door.
To Open During a Dry Cycle
1. Advance the Program selector to "Reset" (the
"Status/Door Lock" LED will blink quickly to
indicate that the cycle has stopped, but the
door is STILL LOCKED).
2. When the "Status/Door Lock" LED blinks
SLOWLY (takes 1-2 minutes), you can open
the door.
IMPORTANT! Once a wash cycle is
underway, the washer/dryer door will LOCK for
the duration of the cycle and will STAY LOCKED
4-24
for up to 2 minutes after the cycle ends. DO NOT
attempt to open the door unless the "STATUS/
DOOR LOCK" LED is BLINKING SLOWLY!
Water Supply Faucets
The washing machine water supply faucets
are located inside the cabinet door above the
machine. Always turn supply faucets off when
not using washing machine to avoid possible
water leaks if a hose or hose gasket should fail.
Water Supply Faucets - Typical View
See Winterization Procedure in Plumbing
section.
Further Information
For complete washer/dryer operating
instructions, see the manufacturer's information
provided in your InfoCase.