Kawai CE220 Owner's Manual page 61

3. Mounting the main body a
Ensure that two or more people undertake the
following step of the assembly process.
Lift the main body a and carefully place it onto the stand.
Position the main body towards the front of the stand, so that
the screws built into the stand are not visible when viewed from
above.
Gently slide the main body backwards until the base engages
with the fixings and locks into place.
When lifting the main body onto the stand and
sliding it into positing, be careful not to catch/
trap hands and fingers.
4. Securing the main body a
Secure the main body to the stand using the four screws (with
the flat washer and spring washer) e.
First, loosely attach all four screws (again leaving a 1-2 mm
tightening allowance), adjusting the position of the main body
on the stand.
When all four screws are attached and the main body is correctly
positioned on top of the stand, securely tighten all screws until
the spring washers collapse.
Tighten all of the other temporarily attached screws securely to
ensure that the main body is firmly attached to the stand.
5. Connecting the pedal and power cables
Connect the pedal cable to the PEDAL terminal located on the
underside of the main body, ensuring the notched plug faces
the rear of the instrument.
Connect the AC power cable i to the AC IN terminal, then use
the binders to fix the cables in place.
Binder
Slide
a
backwards
e
Binder
Pedal plug
notch
61