IBM 3270 Operator's Manual page 42

-~.:-
u? Dial In (Dialing-Originating Display)
This message appears on the display station at which the DIAL key is pressed
and shows that the terminal is waiting for the dial digit number to be keyed in.
On other display stations, the Dial In (
~,,-nn
) message will appear at
the same time.
-~.:-
U U
Dial In (Other Than Dialing Originating Display)
This message appears on display stations other than the one originating the
dial-in. When this message appears, the dial digit number cannot be entered at
the keyboard.
--t---'".;-
Outgoing Call in Process
This message appears after
(I)
the DIRECT key is pressed or (2) the dial digit
number is keyed in and the ENTER key is then pressed. The message means
that the terminal is calling the host system.
~~
tAnn or nn
Outgoing Call in Process with Call Progress Signal
This message appears when the status code (nn or Nnn) is sent back from
the network while an outgoing call is in process; for example, when the host
system is in the manual-answer mode,
~
NO! appears in the Operator
Information Area.
+--~'-
Incoming Call in Process
This message appears when the terminal is being called from the host system.
---z- :,',{:'
Disconnect in Process
This message appears when the terminal is in the process of disconnecting from
the network after receiving the disconnect command or after the DISC key has
been pressed.
-~~ c1'~1 or 5
Cj
C1
Local
This message appears when the terminal is in the local mode. When the LOCAL
key is pressed, the terminal cannot communicate. For the terminal to
communicate, the COMM key must be pressed.
Programmed Symbols
When one of the Programmed Symbol sets (available only when your display
station has the Programmed Symbol Set feature installed) is used, the appro-
priate symbol set indicator will appear in the Operator Information Area. The
symbol set indicators are PSA, PSB, PSC, PSD, PSE, and PSF. When any of
the above symbol sets are indicated and PS selection keys are available,
selectability will be shown in the Operator Information Area, following the
programmed symbol, as follows:
::' : operator selection is permitted and was made by pressing a
Programmed Symbol key.
operator selection is permitted and was made by a Field Inherit
key. Or, selection was made by the host program.
operator selection was not permitted; selection was made by the
host.
Chapter 2. Controls and Indicators 2·26.1