How To Open The Washing Chamber Door In Emergency - Smeg GW3060 User Manual

Press + to access the mask where a deferred starting time can be selected for the chosen cycle:
Pr: deferred
<PLASTIC 70°C>
Digitize period
Ore <00> Min <00>
Starting can be postponed for up to 24 hours.
5.5

HOW TO OPEN THE WASHING CHAMBER DOOR IN EMERGENCY

The washing chamber can only be opened by means of button
In a power failure, the door can be forced open by hand using a flat screwdriver at least 10 cm in length with a
diameter of 3-3.5mm. Proceed as described below to open the door:
. find the hole under the lower profile of the door;
fig 5.6.1.1
. insert the screwdriver into the hole;
. push on the screwdriver delicately without forcing until you hear the closing mechanism release.
The door may be opened during the cycle only if the temperature inside the washing chamber
has not exceeded 40°C. Use the keyboard to open the door.
Depending on the settings chosen for the system, a password must be entered to open the door
during a washing cycle. However, it is always advisable to wait until the cycle terminates before
opening the door.
It is dangerous to open the door when the temperature inside the washing chamber exceeds
50°C!
Smeg declines all liability for damage to persons or property caused by forcing the door open
during a thermal disinfection cycle.
Versione 22.10.08
Manuale GW3060 - User
Use keys + and – to enter the time interval. Use "RH ARROW" and "LF
ARROW" keys to move the cursor
16