Smeg GW3060 User Manual page 39

25 NO PRESS IN HYD SYS: FOAM
26 EVF LEAKAGE
27 EVC LEAKAGE
28 EVD LEAKAGE
29 WASHING
FAILURE
30 SAFETY CHAMBER LEVEL EXCEEDED
31 SAFETY LEVEL FAILED
32 SUMP FULL
33 LACK
CONDENSER
34 CONDENSER DRAINAGE FAILED
35 CONDENSER LEVEL SWITCH FAILED
36 CONDENSER DRAINING PUMP FAILED
37 NOT REACHED TARGET DRAINAGE AT
T=
38 COOLED DRAINAGE FAILED
41 DETERGENT 1 INFLOW FAILED
(flowmeter nr.1 optional)
42 DETERGENT 2 INFLOW FAILED
(flowmeter nr.2 optional)
43 DETERGENT 3 INFLOW FAILED
(flowmeter nr.3 optional)
44 DETERGENT 4 INFLOW FAILED
Versione 22.10.08
Manual GW4090 - User
CHAMBER
OF WATER IN
Check the type of detergent used.
Repeat the cycle.
Check the water supply (cock
open/closed, water pressure,
connection pipe, etc.)
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Check the water supply (cock
open/closed, water pressure,
connection pipe, etc.)
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Check the water supply (cock
open/closed, water pressure,
connection pipe, etc.)
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Make sure that the drain pipe is
DRAINAGE
positioned as indicated in the manual.
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Make a Reset cycle. Repeat the cycle.
Call the Technical Assistance Service
if the fault persists.
Check the water supply (cock
THE STEAM
open/closed, water pressure,
connection pipe, etc.)
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Make sure that the drain pipe is
positioned as indicated in the manual.
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Make sure that the suction tubes of can
P1 are in a good condition and not
squashed. Repeat the cycle. Call the
Technical Assistance Service if the
fault persists.
Make sure that the suction tubes of can
P2 are in a good condition and not
squashed. Repeat the cycle. Call the
Technical Assistance Service if the
fault persists.
Make sure that the suction tubes of can
P3 are in a good condition and not
squashed. Repeat the cycle. Call the
Technical Assistance Service if the
fault persists.
Make sure that the suction tubes of can
P4 are in a good condition and not
39