Smeg GW3060 User Manual page 40

(flowmeter nr.4 optional)
46 PUMP 1 TUBE CLOGGED
47 PUMP 2 TUBE CLOGGED
48 PUMP 3 TUBE CLOGGED
49 PUMP 4 TUBE CLOGGED
50 PUMP 5 TUBE CLOGGED
51 VERIFIY CONNECTIONS
FLOWMETER/PUMPS
52 DOOR 1 ELECTRICALLY OPEN
54 DOOR 1 MECHANICALLY OPEN
56 DOORLOCK 1 FAILURE
58 DRYING 1 FAILURE
60 DRYING 1 SAFETY SWITCH ON
62 HEATING THERMOSTAT ON
63 BLOWER 1 FAILED
65 FAN SENSOR 1 FAILED
67 COOLING FAILED -WARNING: HIGH TEMP
68 TANK 1 EMPTY
69 TANK 2 EMPTY
70 TANK 3 EMPTY
71 TANK 4 EMPTY
73 ARCHIVE ERROR
74 CHAMBER LEAKAGE
75 LACK OF SALT
76 BOILER SAFETY SWITCH ON
77 TEMPERATURE > 45°C
78 RECOVERY FAILED
Versione 22.10.08
Manual GW4090 - User
40
squashed. Repeat the cycle. Call the
Technical Assistance Service if the
fault persists.
See 41
See 42
See 43
See 44
See 45
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Make sure that the door is properly
closed before beginning a cycle. Call
the Technical Assistance Service if the
fault persists.
Make sure that the door is properly
closed before beginning a cycle. Call
the Technical Assistance Service if the
fault persists.
Make sure that the door is properly
closed before beginning a cycle. Call
the Technical Assistance Service if the
fault persists.
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
Press the 2nd button located on the
bottom of the drawer (see §17.1) and
repeat the cycle. If the fault persists,
call the Technical Assistance Service.
Press the 1st button located on the
bottom of the bottom drawer (see
§17.1) and repeat the cycle. If the fault
persists, call the Technical Assistance
Service.
Call the Technical Assistance Service
Call the Technical Assistance Service
Call the Technical Assistance Service
Fill the relative can.
Fill the relative can.
Fill the relative can.
Fill the relative can.
Error inside the microprocessor.
Call the Technical Assistance Service
if the fault persists.
Call the Technical Assistance Service
Fill the softener's salt reservoir (plug
in tub).
If it is present, try to reactivate the
thermostat and repeat the cycle. If the
problem persists, call the Technical
Assistance Service.
Appears (if option selected) if the
temperature of the water entering in
the first phase exceeds 45°C.
Error inside the microprocessor.
Call the Technical Assistance Service