If The Remote Control Does Not Work; Use; Display - Jula Anslut 417-030 Operating Instructions Manual

ENGLISH

If the remote control does not work

The battery could be flat, or the remote control may have broken. You can still start the heat pump by
opening the cover on the indoor part and pressing the emergency switch. The heat pump starts in auto
mode. Press the emergency switch again to switch off the heat pump..

USE

Every time you change a setting the heat pump will stop for a few minutes, and then start again. This is to
prevent cold starts and unnecessary wear on the compressor. After stopping with the remote control it
can take 6-8 minutes before the system starts again. It can take up to 20 minutes before the system starts
working at full power when it is first started.

DISPLAY

Temperature
Fan
Output Night-reduction
Signal Mode
The display is based on very simple logic, with different colours of lamps to explain the operating status.
The signal receiver is located on the bottom left-hand side and must never be blocked.
The Mode lamp is in the second ring from the left. The lamp is red when the system is heating, and blue
when the system is cooling. In dehumidification mode it is white, in auto mode yellow, and in fan mode
green.
The lamp for Output is in the ring in the middle and shows the rate at which the compressor is working.
The lamp is red when the compressor is working at high power, yellow for medium power, and green for
low power.
The ring for the Fan speed is the second from the right, where the logic is the same as for the compressor
speed, i.e. low-medium-high are represented by the colours green-yellow-red.
The ring on the far right shows whether the Night-reduction function is activated. The lamp is yellow when
this function is activated, and off when inactivated.
97