Installation Kit; Positioning Of Indoor Unit; Fitting The Wall Bracket For The Indoor Unit - Jula Anslut 417-030 Operating Instructions Manual

Installation kit

The installation kit consists of two gas-filled
pipes, drainage hose, sealant, diffusion tape, 2
pipe insulation sections, cable ties and electrical
cable with connector
connecting the indoor unit to the outdoor unit.
NOTE Do not remove the plastic plugs on the
pipe sections before starting to install the pipes.

Positioning of indoor unit

The indoor unit should be placed in the room
where the most comfortable temperature is
required. It should not be placed directly
opposite or over sofa and armchairs. The indoor
unit must not be placed closer than 25 cm to the
floor or 15 cm to the ceiling, with a minimum
free space of 15 cm on the sides. The important
thing is to have free space round the indoor unit
to ensure the best distribution of the air. If
placed close to the floor the dampers should be
aligned upwards, since the outflow temperature
can reach over 60C. Wooden floors can shrink
if the indoor unit blows for too long on the same
place, or at too close a range. If the main
purpose of the system is to provide heating the
indoor unit should be placed lower down on the
wall, since heat rises. Keep as much open
space as possible round the indoor unit for the
best possible air flow. Place the indoor unit on
an outer wall to simplify the routing of the pipes.
Note that a gradient is needed for the
condensation hose.

Fitting the wall bracket for the indoor unit

Once the position for the heat pump has been decided it needs to be mounted. Mark up where on the wall
the wall bracket (designs vary according to model) is to be fitted. Note that it must be fitted horizontally.
The position of bracket determines where the hole for the cooling pipe is to be drilled.
ENGLISH
arrangement for
IMPORTANT
Always mount the indoor unit
horizontally.
Piping alternatives:
107
Left
150
250
Right