Indications Of Low Battery; Removing And Replacing The Battery Pack On The Wireless Telephone - SpectraLink Link Wireless User Manual

SpectraLink Corporation Link Wireless Telephone User Guide

Indications of Low Battery

The Wireless Telephone will notify you when the charge on the Battery Pack becomes
low. If the Wireless Telephone is in use, the message will display and you will
BATT
hear a soft beep through the earpiece every six seconds. You have two minutes to
complete the call or change the Battery Pack.
The Battery Pack can be changed while the call is still in progress. Do not press .
END
Quickly remove the discharged Battery Pack and replace with a charged Battery Pack,
press , and then press to resume the call in progress.
PWR START
If the Wireless Telephone is idle, you will hear a brief modulated ring signal and the
Low
message will display. Your Wireless Telephone will not operate until you replace
Battery
the Battery Pack.
Depending on the charging equipment you have purchased, you will either place the
Wireless Telephone in a Charging Stand to charge the Battery Pack, or you will remove
the Pack from the Wireless Telephone and install it in the Charger.
Removing and Replacing the Battery Pack on the Wireless
Telephone
To remove the Battery Pack, press down on the oval button above the Battery Pack on the
back of the Wireless Telephone. Slide the Pack toward the bottom of the Wireless
Telephone until it stops, then lift up.
To replace the Battery Pack, first properly align the top of the Battery Pack with the
arrows on the label on the back of the Wireless Telephone. Gently press and slide the
Pack toward the top of the Wireless Telephone until it snaps into place. You should not
have to force it against the Wireless Telephone.
Take care not to short the Battery contacts on the Pack with metal objects such as coins,
keys or paper clips. Shorting the contacts can cause permanent damage.
Part Number: 72003551H.doc Page 4