Rear Side - Beward N300 Installation & User Manual

3.2. Rear Side

Power connector: for 5 V, 1 A DC power supply.
It is recommended to use the original power supply only for correct camera's operation.
MicroSD card slot: provides recording of information on the microSD/SDHC memory
cards. In case of disconnection an option of automatic backup recording is also available.
Digital I/O: allows you to activate different events by the certain digital input states or such
events when digital output changes its state.
Reset button: when the camera is switched on, press this button to reboot the camera.
Press and hold this button for at least 10 seconds to reset the camera to factory defaults. If a you
hold this button during less than 10 seconds, the camera will reboot without reset to factory
defaults.
Network connector: is used for connection to LAN or to the Internet by a RJ-45 connector.
Moreover, there are a screw hole for attaching a bracket on the rear side and a label which
contains the following information:
 SN: IP camera serial number
 MAC: IP camera MAC address (LAN)
N300 Installation User Manual
Chapter 3. Product Description
Pic. 3.2
8