Table of Contents
Advertisement
Electrical Connections
Measure a minimum of 15.75 in. (40 cm) from the end of the cable,
Step 6.
carefully cut around the outer black cable jacket until you can slide it off,
and remove it. Be careful not to cut into the metal braid beneath the outer
jacket.
Slide the black outer jacket off the cable, exposing the inner metal braid.
Step 7.
Push the braid back over the black outer jacket an inch or two, creating
Step 8.
an area of slack in the braid.
Carefully insert scissor tips into the braid, and cut all the way around it.
Step 9.
Slide the excess braid off the cable and discard it.
Working with the shorter length of braid, trim it so that only 1inch extends
Step 10.
beyond the black outer jacket.
Slide the gland barrel up the cable so that the front edge just lines up
Step 11.
with the end of the black outer cable jacket as shown below.
Carefully fold the metal braid back over the gland barrel as shown.
Step 12.
Trim the metal braid so that the braid is 2 mm past the black O-ring.
Step 13.
14
2 mm
432-0005-00-12 Rev 100 — Voyager III Installation Guide
Advertisement
Table of Contents
