Filling Ink - Roland SJ-740 User Manual

1-5 Switching On the Power for the First Time

Filling Ink

Installing ink cartridges for the first time after purchase requires four SOL INK cleaning cartridges. This is also the case
when you are draining ink in preparation for transport, then reinstalling the ink cartridges.
1 Switch on the main power on the back of the
machine.
Press the [POWER] key on the operation panel.
2
Check the type of ink to install, then press the
3
[ENTER] key.
Follow the messages to make sure the drain
4
bottle is installed at the back of the machine.
Insert cleaning cartridges into the ink-cartridge
5
ports shown by flashing on the display. Insert
the four cartridges firmly, as far as they will go.
Cleaning starts. The cartridges are inserted and removed
while the operation is in progress. Follow the messages
on the display to carry out the procedure.Cleaning may
take some time.
6 When cleaning ends, the following message
appears. Follow the instructions given in the
message to remove the cleaning cartridges.
Finishing all cleaning, return step 5 and step 6.
Firmly insert the SOL INK cartridges for each
7
of the colors as far as they will go.
Ink filling starts.
After ink filling has finished, empty the drain
8
bottle and press the [ENTER] key.
For more information about how to dispose of discharged ink, see "4-5 Disposing of Discharged Ink."
Chapter 1 - Getting Started
30
SELECT INK TYPE
SOL INK LcLm
INSTALL
DRAIN BOTTLE
SET SOL CL - LIQUID
1 2 3 4 5 6 7 8 9 10 11 12
REMOVE SOL CL
1 2 3 4 5 6 7 8 9 10 11 12
SET SOL CRT.
1 2 3 4 5 6 7 8 9 10 11 12