Loading Sheet Media - Roland SJ-740 User Manual

Loading Sheet Media

Before attempting to load sheet media, check the following points.
Front View
Line up the right edge of the media with the guide line,
and align the front edge with the location shown in the
figure.
If the front edge of the media is cut at an angle, load the
media so that its edge is lined up straight with the guide
line.
Be sure to line up the right-hand edge of the media with
the guide line.
If the media is not positioned correctly when you press
the [SETUP] key, the message "SHEET SET ERROR SET
AGAIN" appears on the display.
Rear View
Remove the left-hand media flange at the back of the unit.
Move the right-hand media flange at the back of the unit
to a position where it does not touch the loaded media.
Drape the pulled-out media at the back between the ma-
chine and the media guide.
Front
Media
Align here.
Rear
Media flange
Media
Chapter 2 - Basic Operation
2-2 Loading Media
Guide line
Media flange
Media guide
37