11.6 Reset to Factory Defaults
Resetting your Thomson Gateway
If at some point you can no longer connect to the Thomson Gateway or you want to make a fresh install, it
may be useful to perform a reset to factory defaults.
Warning
A reset to factory default settings deletes all configuration changes you made. Therefore, after the reset a
reconfiguration of your Thomson Gateway will be needed.
Also your wireless clients will have to be re-associated, as described in
Access Point" on page
Methods
You can choose between:
Resetting the Thomson Gateway via the Thomson Gateway GUI
Reset the Thomson Gateway via the Reset button
Resetting the Thomson Gateway via the Thomson Gateway GUI
Proceed as follows:
1
Browse to the
Thomson Gateway
2
On the Thomson Gateway menu, click Configuration.
3
In the Pick a task list, click Reset my Thomson Gateway.
4
The Thomson Gateway restores the initial configuration and restarts.
5
The Thomson Gateway returns to the Thomson Gateway home page (unless the IP address of your
computer is not in the same subnet as the default IP address of the Thomson Gateway, being
192.168.1.254).
Reset the Thomson Gateway via the Reset button
Proceed as follows:
1
Make sure the Thomson Gateway is turned on.
DMS-CTC-20101208-0018 v1.0
39.
GUI.
"5 The Thomson Gateway Wireless
Support
105