Exit Menu; Exit From The Setup Procedure - Datalogic Formula F7400 User Manual

F7400 - USER MANUAL _________________________________________________________
ITEM
Disk
If the Power Manegement - Automatic parameter is selected OFF, all Activities
parameters have no meaning.
5.7.

EXIT MENU

ITEM
CMOS + EEPROM
Save & Exit
CMOS Save & Exit Saves the new values in the CMOS
Discard
Factory parameters Load the default factory values
5.8.

EXIT FROM THE SETUP PROCEDURE

To end the SETUP procedure, you will have to:
1 - Select the Exit menu by pressing [ESC]
2 - Select one of the items by pressing the correct key (an erroneus one re-enters
the setup procedure):
- If you exit with saving, a message appears notifying that the program is about
to quit, and you can choose to reboot the F7400 terminal to see the effects
of the new configuration. Remember that the F7400 terminal parameters are
used by BIOS at boot-time.
- If you exit with the "Discard" command, no change will affect CMOS and
EEPROM memories.
- If you choose the "factory parameters", the application applies it and then
re-enters the setup procedure.
34
VALUES
Off
Primary (*)
Secondary
DESCRIPTION
Saves the new values in the CMOS
memory and EEPROM memory and
exits
memory and exits.
Discards the new values and exits
DESCRIPTION
Indicates the level of
activity for all
accesses to flash disk
(boot and non-boot)
NOTES
Press [S] to activate
the function
Press [C] to activate
the function
Press [Q] to activate
the function
Press [D] to activate
the function
5
Ed.: 06/00